Get A Quote
  • Created by Eagle Eyefrom Noun Project HTPS-DOC 005 Products

Patented. Proven. Pressure rated.

Every HTPS product exists to solve one problem: moving corrosive, abrasive slurry at pressure without failure. Each datasheet below is drawn from technologies with more than 20 years of proven hydro transport duty.

MANUFACTURED IN WADEVILLE, JOHANNESBURG

BUTT WELDING TO ISO 21307:2017

  • Created by Eagle Eyefrom Noun Project Capability Manufacturing

Built in-house.
Controlled end to end.

18

m

Maximum spool length

100

mm

From 114 mm OD

800

mm

To 813 mm OD

ISO

21307:2017 butt welding
System Engineering

Pressure-rated
from end to end.

Steel strength, engineered lining and a jointing interface developed as one complete transport system.
Lining Detail

Performance you can see.

A cutaway view makes the protected flow path and flange interface immediately clear.
SLUR-e-JOIN™
DS-01 · JOINTING SYSTEM

The next generation in medium pressure flanged HDPE lined steel pipe spools. SLUR-e-JOIN™ uses a complete precision pre-machined embedded HDPE stub, butt welded to ISO 21307:2017, creating a flange-to-flange joint superior in pressure and load capability.

No gaskets required.

  • Joints perfectly with HDPE flat face stub or O-ring HDPE stub interfaces
  • Bolts directly onto full face rubber lined systems
  • Gaskets can be applied to partial rubber surfaces where required
  • Superior pressure and load capability from the bolted flange-to-flange design
Technical Summary
Joint type
Flange-to-flange, bolted
Stub
Precision pre-machined embedded HDPE
Welding standard
ISO 21307:2017
Pressure class
Medium pressure duty
Gaskets
Not required
Compatibility
HDPE flat face, O-ring stub, rubber lined systems
HDPE Lined Fittings Range
DS-04 · FITTINGS & CLOSURES

A simple yet specialised solution: four standard fittings providing uniformity and consistency, containing cost and improving the ability to fabricate quickly. Bend it, but do not break it: it is all about the flow.

  • HDPE lined bends from 5D to 7D long radius
  • Angles: 10, 15, 20, 22.5, 30 and 45 degrees
  • T-pieces, reducing T-pieces and laterals
  • Custom T-pieces, laterals and bends manufactured to customer requirements
  • Full range of HDPE lined closures for project completion
Technical Summary
Standard bends
10° / 15° / 20° / 30° / 45°
Radius
5D long radius (up to 7D available)
Design intent
Optimised flow-rate characteristics
Custom work
T-pieces, laterals, bends to spec
Fabrication partner
CSP Engineering, co-located in Wadeville

Need a datasheet or a custom fitting?

Send us your duty conditions and we will match the product to the pipeline.

Request Specifications